林奕含的老师陈国星:求高手帮帮忙~~~英文

来源:百度文库 编辑:中科新闻网 时间:2024/05/01 15:03:53
通过混凝和化学氧化两种方法分别对某纺织集团印染废水进行处理,影响混凝的条件为pH、PAC的投加量和反应时间,得出最佳混凝条件为pH=12,PAC加入量为12mL/200mL;影响氧化的条件为H2O2投加量、FeSO4•7H2O投加量、pH和反应时间,得出最佳氧化条件为H2O2投加量4ml/200mL,FeSO4•7H2O投加量300mg/200mL,pH值为4,时间为60分钟。实验结果表明,单一的混凝和单一的化学氧化都可使印染废水的CODCr去除率与脱色率达到国家《纺织染整工业水污染物排放标准》(GB4287-92)的一级排放标准。

Through concrete and chemical oxidation are two methods of a group of textile wastewater textile processing, the impact of aggregate conditions for pH, the Pac voted to increase the volume and response time, resulting in the best conditions for pH=12,PAC to aggregate volume of 12mL/200mL; impact oxidation conditions for H2O2 vote plus volume, FeSO4 • 7H2O vote plus volume, pH and response time, resulting in the best conditions for H2O2 oxide vote plus volume increases in the volume 300mg/200mL,pH 4ml/200mL,FeSO4 • 7H2O vote for the value of 4 hours 60 minutes. Experimental results show that a single aggregate and can enable printing of a single chemical oxidation removal and wastewater CODCr Detreated rate of the national "textile dyeing industry water pollutant discharge standards" (GB4287-92) level emissions standards.

Oxidize two methods through the coagulation and chemistry to carry on processing separately to some textile group printing waste water, affects the coagulation the condition is pH, PAC throws the increment and the reaction time, obtains the best coagulation condition is pH=12, PAC joins the quantity is 12mL/200mL; The influence oxidation condition is H2O2 throws the increment, FeSO4 □7H2O throws the increment, pH and the reaction time, obtains the best oxidized condition is H2O2 throws increment 4ml/200mL, FeSO4 □7H2O throws increment 300mg/200mL, the pH value is 4, the time is 60 minutes. The experimental result indicated that, the sole coagulation and the sole chemistry oxidation all may cause the printing waste water CODCr removing rate and the decolorization rate achieved the country "Spinning and weaving Dyes the Entire Industry Water pollution Discharges Standard" (GB4287-92) a level to discharge the standard